(2,00mm) .0787" thsc series (2,00mm) .0787" pitch 38 awg micro ribbon coax cable header or socket termination thsc?120?07.50?tu?su?1 thsc?110?06.50?su?td?3 www.samtec.com specifications for complete speci cations see www.samtec.com? thsc cable: 38 awg coax micro ribbon signal routing: 50 single-ended overall length: (152mm) 6" to (1m) 40" standard cable flexing life: >40,000 cycles cable bending radius: <2,5mm plating: au over 50? (1,27?) ni current rating: 300 millamp max propagation delay: 4.5 nsec/meter operating temp range: -40? to +105? rohs compliant: ye s important note: for optimal performance, at least one transmission line must be dedicated to ground. for more information, go to www.samtec.com/cable_ builder/xhsc_grounding.asp note: contact samtec for high speed characterization. note: cable lengths longer than 40.00" (1 meter) are not supported with s.i. test data. note: verify part number with samtec s interactive cable builder at www.samtec.com/ cable_builder/pitch.aspx note: this series is non-standard, non-returnable. ?10 ?13 ?20 ?22 ?25 no. of positions a (28,37) 1.117 (32,39) 1.275 (48,39) 1.905 (52,37) 2.062 (52,37) 2.062 ?tx ?sx end b (9,32) .367 (10,85) .427 mates with: sqt, sqw, esqt, smm, tcsd, tmmh, tmm, mtmm, mmt, tw, ltmm, zltmm, esqt application mated with sqt or ltmm. processing conditions will affect mated height. (12,50) .492 wire length (1,27) .050 oal = wire length + (15,24) .600 02 02 a (14,61) .575 b 01 01 no. of pins per row end no. 1 wire length end no. 2 ??xx.xx? = wire length in inches (152mm) 06.00" minimum 10, 13, 20, 22, 25 (call for other sizes) thsc 1 ?1 = pin 1 to pin 1 ?2 = pin 1 to pin 2 ?3 = pin 1 to second last pin ?4 = pin 1 to last pin wiring option ?tu = terminal up ?td = terminal down ?su = socket up ?sd = socket down end no. 2 (?u sho wn) end no. 1 (?u shown) f-210-1 supplement high speed cable assemblies cable length rated @ 3db insertion loss thsc 10" (254mm) 175 mhz / 0.35 gbps performance and complete test data available at www.samtec.com?thsc or contact sig@samtec.com
|